News
Position:Index > News
Galvanized equipment manufacturers to tell you how to deal with Floor jointing
Time:2015-4-24 9:24:36
Galvanized equipment manufacturers to tell you how to deal with Floor jointing.
(1) Mortar
joint treatment
Prior to the jointing
construction, the concave joints between boards must be brushed with clean oil
brush without being contaminated by dirt.
Evenly paint a layer of
epoxy resin plaster in the joints as bottoming to strengthen the binding power
between the plaster and jointed board binding course materials. You must brush
a layer of primer on the epoxy resin plaster material binding course and the
jointing work can only be done after the drying of primer.
(2) Jointing
Put the just prepared
epoxy resin plaster on different supporting plates with handles, scrape a small
amount of plaster with a paint knife to fill in the joints vigorously along the
sides of the joints; the plaster in the joints must be compact without gaps or
bubbles, and their surfaces must be evenly scraped or slightly concave; the
residual plaster on the plates must be removed with a paint knife and the
stains can be washed off with oil brush using a little acetone. The granite
terrace joints are 8~10mm wide and the depth of the joints shall be based on the thickness of
the plates.
Galvanizing equipment, welcome to our company to buy.
Prev:Flooring work